Stainless Steel Fast Twist Connector

Name: 304/316 stainless steel stainless steel Fast twist connector

Inch thread: 1 minute equals 1/8; 2 minutes, 1/4; 3 minutes, 3/8; 6 minutes, 1/2;

Areas of application:

The steel pipe is inserted into the ferrule, secured with the ferrule nut, made contact with the ferrule, cut into the tube, and sealed. It also helps to avoid the drawbacks associated with accidental welding. The card sleeve type pipe junction is assembled as follows:

The quality of the assembly has a direct impact on how well the ferrule type pipe joint performs in addition to the part's material, manufacturing precision, heat treatment, etc. As a result, this is how it should be put together.

1. You can either cut the pipe by hand or on a special machine to the desired length. The cut plane's perpendicularity to the pipe's center line shouldn't be greater than half of the pipe's external tolerance.

2. Clean the debris, metal shavings, and inner and outer round burrs from the pipe end.

3. Clean each component of the pipe junction of any anti-rust oil and debris.

4. Arrange the curtain, fasten the ferrule to the tube, and then insert the tube into the connector body's bottom-most taper hole. Turn the tube until it stops while tightening the nut, then tighten it another one and a third turns.